I started working on my tractor on the 15th of January. We started off by taking off the hood and then we just started working on pulling parts off that need to come off to see if the block was good or not. After we took the manifold off we could see the block and knew that we had to buy a new block. The week after that week we pulled the whole motor out of the tractor and started getting the motor all tore down to just the block. Seth and I took my manifold to Mitchell to get cleaned. I am kind of stalled out until I get my new block which should be by the end of this week.
0 Comments
Moving my tractor over to Plankinton was a challenge. The rear wheels were locked up so the tractor would not roll at all. So Dad and I had to lift the front end of the tractor up and back the trailer underneath the tractor. Once we had the front end on the trailer Dad lifted up the back end and then pushed the tractor up onto the trailer. The tractor was a little too wide for the trailer but Dad and I managed to get it over to Plankinton with no problems.
|
AuthorThis is a blog that I use to right reflections about my senior project!!! Archives
March 2017
Categories |